Backup Lamp: Service and Repair

REMOVAL PROCEDURE
1. Remove the 2 stage rivets (2) (2 each side) that retain the outboard lamp fillers to the backup lamp assembly (1).
2. Press the center of the rivet (2) until a click is heard.
3. Remove the rivet (2) from the filler.
4. Remove the nuts (3) that retain the backup lamp (1) to the rear compartment lid.
5. Remove the bulb sockets from the lamp.
6. Remove the backup lamp (1).

INSTALLATION PROCEDURE
1. Install the bulb sockets to the lamp (1).
2. Install the backup lamp (1).

NOTICE: Refer to Fastener Notice in Cautions and Notices.

3. Connect the nuts (3) to the lamp.

Tighten
Tighten the nuts (3) to 5 N.m (44 lb in). Tighten the nuts in the sequence shown in the illustration.

4. Reset the 2 stage rivets (2) so that the center of each rivet (2) is outboard.
5. Install the rivets (2) to the lamp fillers.

IMPORTANT: Do not rework or alter the reflective surface of the taillamps.

6. Press the center of the rivets (2) in order to lock the rivets into position.