Tail/Stop/Turn Signal Lamps

Voltage is applied when the ignition is in the RUN position through the TURN B/U Fuse in the fuse block, to the turn signal lamp flasher through circuit 141. Then voltage is applied from the flasher to the turn/hazard switch through circuit 16. When the turn signal switch is placed in the TURN LEFT position, voltage is applied through the closed contacts of the turn signal switch, to the LH tail/stop/turn lamp through circuit 18. The LH tail/stop/turn lamp is grounded through circuit 1250. When the turn signal switch is placed in the TURN RIGHT position, voltage is applied through the closed contacts of the turn signal switch, to the RH tail/stop/turn lamp through circuit 19. The RH tail/stop/turn lamp is grounded through circuit 1250.