Changing the Locking Control Mode

Perform the following procedure to change the locking control mode:
1. Turn off the IP dimmer switch.
2. Turn the ignition switch to the OFF position.
3. Remove the MALL PGM Fuse.
4. Turn the ignition switch to the ACC position.
^ The Body Control Module (BCM) sounds the chime a number of times equivalent to the BCM type installed on the vehicle (1, 2, 3, or 4 chimes).
^ Now the BCM has entered the feature customization mode.
5. To change the locking control mode, press and release the UNLOCK on either door lock switch.
^ The BCM sounds the chime a number of times equivalent to the locking control mode. A transition past mode 4 repeats the sequence starting with mode 1.

The locking control modes are as follows:
^ Mode 1: Last door closed locking and lockout prevention are disabled.
^ Mode 2: Lockout prevention is enabled.
^ Mode 3: Last door closed locking is enabled.
^ Mode 4: Last door closed locking and lockout prevention are enabled.

To exit and save the current customization mode:
1. Turn the ignition switch to the OFF position.
2. Reinstall the MALL PGM Fuse.

If unable to change locking modes, refer to Table 13 for diagnosis and repair. Table 13 Cannot Change/Update Feature Customization Modes