Blower Motor Resistor: Service and Repair

Remove or Disconnect

1. Right side instrument panel insulator.
2. Electrical connectors from blower motor resistor.
3. Loosen (do not remove) both forward mounting screws.
^ Blower motor resistor opening is slotted as access is extremely limited.
4. Rearward mounting screw.
5. Blower motor resistor.

Important
^ Care must be taken when removing the blower motor resistor. The resistor is a ceramic card for (C60).

Install or Connect

1. Blower motor resistor.
2. Rearward mounting screw.

Tighten
^ Screw to 1.5 N.m (13 lb. in.).

3. Tighten both forward mounting screws.

Tighten
^ Screws to 1.5 N.m (13 lb. in.).

4. Electrical connectors to blower motor resistor.
5. Right side instrument panel insulator.