Closeout/Insulator Panel Replacement - Right

REMOVAL PROCEDURE
1. Remove the sound insulator screws from the IP (1).
2. Remove the sound insulator screws (3) and the wing nuts (4) from the studs on the cowl.
3. Pull the sound insulator (2) down and rearward.
4. Remove the courtesy lamp if necessary.
5. Remove the sound insulator.

INSTALLATION PROCEDURE
1. Install the courtesy lamp if necessary. Perform the following steps:
1.1. Position the sound insulator (2) under the dash.
1.2. Insert the cowl studs (3) through the holes in front of the insulator.
1.3. Route the passenger inflator module pigtail around courtesy light.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the sound insulator screws to the IP (1).

Tighten
Tighten the fasteners to 1.9 N.m (17 lb in).

3. Install the wing nuts (4) to the studs.