Programmer Replacement

REMOVAL PROCEDURE

1. Remove the right sound insulator.
2. Disconnect the vacuum connectors (9) from the programmer (1).
3. Disconnect the side electrical connector.
4. Remove the rod from the temperature valve link.
5. Remove the screws That attach the programmer to the vehicle.
6. Disconnect the actuator connector from the temperature valve.
7. Remove the programmer (1).

INSTALLATION PROCEDURE

1. Install the programmer (1) into position.
2. Connect the actuator connector to the temperature valve.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the screws in order to attach the programmer (1) to the vehicle.

Tighten
Tighten the screws to 1.4 N.m (12 lb in).

4. Connect the vacuum connector (2) to the programmer (1).
5. Connect the side electrical connector to the programmer (1).
6. Install the temperature valve link rod to the air mix valve.
7. Adjust the rod to the temperature valve link. Refer to Temperature Valve Link Adjustment.
8. Install the right sound insulator.