Tail Lamp: Service and Repair

REMOVAL PROCEDURE



1. Remove the rear compartment sill panel trim.
2. Remove the nuts (4) that retain the taillamp (1).
3. Disconnect the lamp harness connector (3).
4. Remove the taillamp (1).

INSTALLATION PROCEDURE



1. Install the taillamp (1).
2. Connect the lamp harness connector (3).




NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: Do not rework or alter the reflective surface of the taillamps (1).

3. Install the nuts in order to retain the taillamp.

Tighten
Tighten the nuts to 5 N.m (44 lb in). Tighten the nuts in the sequence shown in the illustration.

4. Install the rear compartment sill panel trim.