P1276

Circuit Description

The Accelerator Pedal Position (APP) sensors are mounted on the accelerator pedal/TAC module assembly. There are three individual Accelerator Pedal Position sensors within one housing. Three separate signal, ground and reference circuits are used which are contained within the Throttle Actuator Control (TAC) Module. The APP sensor signal voltage increases as the Accelerator pedal is depressed. The signal circuits pull to ground within the TAC module.

Conditions for Running the DTC

^ DTCs P0606, P1517, P1518 are not set.
^ The ignition switch is in the crank or run position.

Conditions for Setting the DTC

^ APP sensor 1 disagrees with APP sensor 2 by more than 10.5% and APP sensor 1 disagrees with APP sensor 3 by more than 10.5%.
^ All of the above conditions met for less than 1 second.

Action Taken When the DTC Sets

^ The PCM will not illuminate the Malfunction Indicator Lamp (MIL).
^ The PCM will store conditions which were present when the DTC set as Fail Records data only. This information will not be stored as Freeze Frame data.

Conditions for Clearing the MIL/DTC

^ A history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ DTC can be cleared by using the scan tool Clear Info function.

Diagnostic Aids

Important: Remove any debris from the connector surfaces before servicing a component. Inspect the connector gaskets when diagnosing/replacing a component. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion.

^ Corrosion may cause an intermittent condition.
^ For an intermittent condition, refer to Symptoms. Symptom Related Diagnostic Procedures
^ If you complete a repair and the DTC was cleared using a scan tool on the same ignition cycle, the default action will not clear until an ignition cycle has occurred.
^ When the TAC module detects a problem within the ETC System the PCM receives a message across serial data and more than one ETC System related DTC may set. This is due to the many redundant tests run continuously on this system. Locating and repairing one individual problem may correct more than one DTC. Keep this in mind when reviewing captured DTC info.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

6. When the TAC module detects a problem within the ETC System the PCM receives a message across serial data and more than one ETC System related DTC may set. This is due to the many redundant tests run continuously on this system. Locating and repairing one individual problem may correct more than one DTC. Keep this in mind when reviewing captured DTC info.