Set/Coast Button Switch

The cruise control SET/COAST button switch (3) is located in the end of the turn signal multifunction lever The cruise control SET/COAST button switch (3) has the following 2 positions:
^ NORMAL
^ DEPRESSED

Perform the following steps in order to set the cruise speed:
1. Press the SET/COAST button switch (3) when you have reached the desired speed.
2. Release the SET/COAST button switch (3).

Set Position
Ensure that the following conditions are met:
^ The OFF-ON-R/A switch (2) is ON
^ The vehicle exceeds the minimum speed limit of 40 km/h (25 mph).

The system will cruise within 1.6km/h (1 mph) of the actual selected speed.
The system will cruise until one of the following actions occur:
^ The OFF-ON-R/A switch (2) is turned to the OFF position.
^ The ignition switch is turned OFF
^ The SET/COAST button switch (3) is fully pushed in and held in.

Pressing the brake pedal will cause the SET/COAST button switch (3) to release. This does not release the resume capability.

Coast Position
Press and hold the SET/COAST button switch (3) in order to lower the vehicle speed. By depressing the SET/COAST button switch (3), the cruise control system is disengaged and allows the throttle to return to the idle position. When the vehicle attains the desired speed, release the SET/COAST button switch (3). The cruise control system will re-engage at this new speed.

Perform the following steps in order to lower the cruise speed in increments of 1.6 km/h (1 mph) using the SET/COAST button switch (3):
1. Quickly press and release the SET/COAST button switch (3).
2. Tap the SET/COAST button switch (3).

Do not hold the SET/COAST button switch (3) in the depressed position, the cruise control system will engage the coast mode.

Use the accelerator pedal in order to override the cruise system.

Release the accelerator pedal in order to return to the previous cruise speed.