Headlamp Leveling Actuator Replacement

REMOVAL PROCEDURE




IMPORTANT: The headlamp leveling actuator (Export Only) is part of the headlamp and must be replaced with the headlamp.

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.




2. Remove the headlamp housing bracket bolt attaching the headlamp to the headlamp bracket.
3. Slide the headlamp outboard to disengage the headlamp tabs from the headlamp bracket slots.




4. Pull the headlamp forward to access electrical connectors.
5. Disconnect the headlamp electrical connectors.




6. Disconnect the headlamp leveling actuator electrical connector.
7. Remove the headlamp.

INSTALLATION PROCEDURE



1. Connect the headlamp leveling actuator electrical connector.




2. Perform the following to install the headlamp:
2.1. Disconnect the headlamp electrical connectors.
2.2. Engage the tabs on the back of headlamp into the slots in the headlamp bracket.





NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the headlamp housing bracket bolt attaching the headlamp to the headlamp bracket.

Tighten
Tighten the headlamp housing bracket bolt to 7 N.m (62 lb in).




4. Connect the negative battery cable.