Fuel Tank Pressure Sensor: Service and Repair

Fuel Tank Pressure Sensor Replacement

REMOVAL PROCEDURE
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
2. Drain fuel tank. Refer to Fuel Tank Draining Procedure.
3. Raise the vehicle. Go to Vehicle Lifting in Service Precautions.
4. Remove the fuel tank.
5. Remove the electrical connector from the fuel tank pressure sensor.
6. Remove the fuel tank pressure sensor (10) from the modular fuel sender.

INSTALLATION PROCEDURE
1. Install the new fuel tank pressure sensor (10) to the modular fuel sender.
2. Connect the electrical connector to the fuel tank pressure sensor.
3. Reinstall the fuel tank.
4. Refill the fuel tank.
5. Reconnect the negative battery cable.
6. Inspect for fuel leaks.
6.1. Turn the ignition switch ON for 2 seconds.
6.2. Turn the ignition switch OFF for 10 seconds.
6.3. Turn the ignition switch ON.
6.4. Check for fuel leaks.