Remote Keyless Entry (RKE) - Transmitter

IMPORTANT:
^ When you replace a lost or damaged transmitter, program all of the remote control door lock transmitters.
The first transmitter code that you program will always be in all four memories unless additional transmitters are programmed.
^ Program the remote keyless entry system for one vehicle at a time.
If you program two or more vehicles and the vehicles are close to each other, one transmitter could be programmed to more than one vehicle.

1. Turn the ignition switch to the OFF position.
2. Remove the RADIO fuse from the fuse block.
3. Cycle the ignition switch from the OFF position to the RUN position 3 times within 5 seconds.
The Body Control Module (BCM) will verify entry into the programming mode by performing the following actions:
3.1. Locking both of the doors
3.2. Unlocking the driver door
3.3. Releasing the rear compartment lid

4. Press and hold both the LOCK and UNLOCK buttons on the remote control door lock transmitter for approximately 15 seconds. The following actions will occur:
^ The BCM will confirm that the transmitter code is programmed by performing the following actions:
4.1. Locking both of the doors
4.2. Unlocking the driver door
4.3. Releasing the rear compartment lid
^ Any transmitter code that was previously programmed is erased.
^ The BCM is programmed to the transmitter.

5. If you are programming the BCM to match additional remote control door lock transmitters, repeat step 4. You may program upto 4 transmitters. This must be done before the RADIO fuse is reinstalled.
6. Place the ignition switch in the OFF position.

IMPORTANT: The remote keyless entry system will not be operational if the program input line (RADIO fuse) is open.

7. Reinstall RADIO fuse to the fuse block.