Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE

IMPORTANT: The PCM Idle Learn Procedure must be performed whenever the battery is disconnected. Refer to CKP System Variation Learn Procedure. Perform the CKP System Variation Learn Procedure when the Crankshaft Position sensor is removed or replaced.




1. Remove the starter.




2. Disconnect the Crankshaft Position (CKP) sensor electrical connector.




3. Remove the CKP sensor retaining bolt.
4. Remove the CKP sensor.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the CKP sensor.
2. Install the CKP sensor retaining bolt.

Tighten
Tighten the CKP sensor to 25 N.m (18 lb ft).




3. Connect the CKP sensor electrical connector.




4. Install the starter.
5. Lower the vehicle.
6. Connect the negative battery cable.
7. Perform the CKP System Variation Learn Procedure. Testing and Inspection
8. Perform the Idle Learn Procedure. Testing and Inspection