Keyless Entry Receiver: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Open the rear compartment lid.
3. Remove the remote door lock receiver. The receiver is located between the rear package shelf and the rear package shelf cover, just to the right of the center access hole. Compress the retaining tabs. Slide the remote door lock receiver down through the access hole.
4. Disconnect the electrical connector from the remote door lock receiver.

INSTALLATION PROCEDURE

1. Connect the electrical connector to the remote door receiver.
2. Install the receiver through the access hole. Ensure that the mounting tabs lock into place.
3. Close the rear compartment lid.
4. Connect the negative battery cable.
5. Reprogram the new receiver to the transmitter(s). Refer to Transmitter Programming. Service and Repair