Crankshaft Position (CKP) Sensor Replacement (7X)

7X Crank Shaft Position (CKP) Sensor:

REMOVAL PROCEDURE
1. Turn the steering wheel fully to the left.

CAUTION: Refer to Caution in Service Precautions.

2. Raise vehicle on hoist.
3. Disconnect sensor electrical connector.
4. Remove bolt/screw.
5. Remove sensor from engine.
6. Inspect for the following:
6.1. Inspect the sensor for wear, cracks, or leakage. Replace the O-ring if necessary.
6.2. Lubricate the new O-ring with clean engine oil before installing.

INSTALLATION PROCEDURE
1. Install the sensor to the block.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Reinstall the retainer bolt to hold sensor to block face.

Tighten
Tighten the bolt to 8 N.m (71 lb in).

3. Connect the electrical connector.
4. Lower the vehicle.