Installation Procedure

1. Install the SDM (5) to the vehicle.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the Inflatable Restraint Sensing and Diagnostic Module (SDM) mounting fasteners (1).

Tighten
Tighten fasteners to 10.0 N.m (89 lb in).

3. Install the SDM harness connector (3) to the SDM (5).
4. Install the Connector Position Assurance (CPA) (2) to the SDM harness connector.
5. Position the carpet to cover the Inflatable Restraint Sensing and Diagnostic Module (SDM).
6. Install the RF seat belt anchor bolt.
7. Install the passenger front carpet retainer.
8. Install the front passenger seat.
9. Enable the SIR system.