Automatic Transaxle-3T40

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Remove the shift linkage.
3. Disconnect the electrical connector.





4. Remove the park/neutral position switch mounting bolts.





5. Remove the park/neutral position switch assembly.


Installation Procedure
Using Old Switch
1. Place the shift shaft in N (Neutral).
2. Align the flats of the shift shaft with the switch.

Notice: Refer to Fastener Notice in Service Precautions.





3. Install the park/neutral position switch mounting bolts.
^ Tighten the bolts to 24 Nm (18 ft. lbs.).

Important: Ensure that the engine will only start in the P (Park) or the N (Neutral) position. Readjust the switch if the engine will start in any other position.

4. Connect the negative battery cable.