T/L ASSY &/or Backup, Sidemarker, Stop, Turn SIG Bulb Rep

REMOVAL PROCEDURE




1. Pull back the rear compartment trim. Refer to Compartment Trim Panel Replacement - Rear in Trunk/Liftgate.
2. Remove the taillamp thumb nuts from the taillamp.




3. Remove the taillamp from the rear body panel.
4. Disconnect the electrical connector from the taillamp.




5. Release the tabs to remove the circuit board from the taillamp
6. Remove the required bulb(s) from the socket(s), if replacing bulbs.

INSTALLATION PROCEDURE




1. Install the required bulb(s) to the socket(s), if replacing bulbs.
2. Install the circuit plate to the taillamp, pressing into place until the retainers are fully seated.




3. Connect the electrical connector to the tailtamp.




4. Position the taillamp to the rear body panel.
5. Install the taillamp thumb nuts, and hand tighten.
6. Fold the rear compartment trim to the original position. Refer to Compartment Trim Panel Replacement - Rear in Trunk/Liftgate.