Removing the Customers Code

IMPORTANT: Either the customers code or the factory backup code can be used in order to remove the customers code.

Perform the following steps in order to remove the customers code:

1. Turn the ignition to the ACC or RUN position.
2. Turn the radio OFF.

IMPORTANT: If the display changes to --- the theft deterrent is deactivated and no code is stored.

3. Press and hold pushbuttons 1 and 4 for approximately 6 seconds until the display changes to SEC.
4. Press the HR button.
5. Set the first 2 digits (0-19) of the code with the HR button.
6. Set the next 2 digits (0-99) of the code with the MIN button.
7. Press the AM-FM button in order to enter the code.
8. The theft deterrent is de-activated when --- is displayed and then the clock is displayed.