Power Trunk / Liftgate Lock Switch: Service and Repair

REAR COMPARTMENT LID SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Remove the door trim panel.

IMPORTANT: When removing any switch, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch when using a metal tool to remove the switch from the wiring harness.




2. Disengage the electrical connector from the rear compartment lid switch (1).
3. Using a small, flat-bladed tool, remove the lid switch from the mounting bezel.

INSTALLATION PROCEDURE




1. Press the rear compartment lid switch (1) into the mounting bezel.
2. Connect the electrical connector to the switch.
3. Install the door trim panel.