Ignition Lock Cylinder

Ignition Lock Cylinder and Switch Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.





1. Disconnect the negative battery cable.

2. Remove the lower steering column cover panel by removing the screws.





3. With the key in the ignition, turn to ACC and remove the lock cylinder. To remove the lock cylinder of the switch cylinder housing, press down the detent spring with a 2.5 Allen wrench, or other suitable tool, and pull out the lock cylinder.





4. Remove the ignition switch retaining screw.
5. Disconnect the wiring and remove the ignition switch.

Installation Procedure


Notice: Refer to Fastener Notice in Service Precautions.




1. Install the ignition switch with the ignition switch retaining screw.
Tighten the ignition switch retaining screw to 2 Nm (18 inch lbs.).

2. Connect the wiring to the ignition switch.





3. Install the lock cylinder.
4. Install the lower steering column cover panel with the screws.
Tighten the lower steering column cover panel screws to 3 Nm (27 inch lbs.).

5. Connect the negative battery cable.