Lock Replacement - Rear Door

Lock Replacement - Rear Door

Removal Procedure





Caution: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the door seal trim. Refer to Water Deflector Replacement - Door (Service and Repair) .
3. Disconnect the inside door handle and the lock rods.




4. Disconnect the outside door handle and the lock rods.




5. Remove the bolts and the guide rail.




6. Remove the screws and the lock.
7. Disconnect the electrical connector.
8. Disconnect the lock rods at the lock.



Installation Procedure






Notice: Refer to Fastener Notice in Cautions and Notices.

1. Install the rear door lock with the screws.

Tighten the rear door lock screws to 8 N.m (71 lb in).





2. Connect the electrical connector.
3. Install the guide rail with the bolts.

Tighten the guide rail bolts to 7 N.m (62 lb in).





4. Connect the outside door handle and the lock rods.




5. Connect the inside door handle and the lock rods.
6. Install the door seal trim. Refer to Water Deflector Replacement - Door (Service and Repair) .
7. Connect the negative battery cable.