Evaporative Emission Control Canister: Service and Repair

EVAPORATIVE EMISSION (EVAP) CANISTER REPLACEMENT

REMOVAL PROCEDURE




1. Remove the bolt that secures the canister flange to the vehicle.

CAUTION: Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime work is being done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.

2. Slide the canister out of the track holder.
3. Disconnect the canister fuel vapor hoses.
4. Remove the canister cover.
5. Remove the canister.

INSTALLATION PROCEDURE




1. Insert the canister into the track and slide it into position.
2. Connect the canister fuel vapor hoses.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the evaporative emission (EVAP) canister flange bolt to 4 N.m (35 lb in).

3. Install the canister flange bolt.