Transmission Cooler Pipes and Hoses Replacement (Inlet)
Transmission Cooler Pipes and Hoses Replacement (Inlet)
Removal Procedure
1. Notice:
Refer to Vehicle Lifting.
Raise and support the vehicle.
2. Drain the transaxle fluid.
3. Remove the clip from the radiator threaded connector, then disconnect the fluid cooler hoses.
4. Remove the fluid cooler inlet pipe bolt from the transaxle.
5. Remove the inlet pipe fitting nut from the transaxle.
6. Remove the fluid cooler inlet pipe and hoses.
Installation Procedure
1. Notice:
Refer to Fastener Notice in Service Precautions.
Install the fluid cooler inlet pipe fitting nut into the transaxle.
Tighten the fluid cooler inlet pipe fitting nut to 35 Nm (26 ft. lbs.).
2. Install the fluid cooler inlet pipe bolt into the transaxle.
Tighten the fluid cooler inlet pipe bolt to 9 Nm (80 inch lbs.).
3. Connect the fluid cooler hoses and install the clip into the radiator threaded connector.
4. Lower the vehicle.
5. Fill the transaxle with the fluid.