Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement

Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement

Removal Procedure

Caution: Refer to Restraint System Service Precautions.

1. Remove the lumbar knob, if equipped.






Important: Take special care when removing the trim. Start at the arched portion, and work counter-clockwise around the trim, ending at the upper most point. To disengaged the upper most clip, pivot the trim forward.

2. Remove the inflatable restraint side impact module trim (1).




3. Starting at the top of the seat back panel, remove the push-in retainers by pulling the panel from the seat back frame.
4. Remove the seat back panel from the seat back frame by pulling straight up to release the lower hooks.
5. Remove the seat back panel.

Installation Procedure




1. Install the seat back panel to the seat back frame.
2. Engage the lower hooks to the seat frame.
3. Push at the top of the seat back panel to install the push-in retainers to the frame.
4. Install the lumbar knob, if equipped.




5. Install the inflatable restraint side impact module trim (1).