Data Communications

DTC B1001

DTC Descriptors
DTC B1001 4B
- Option Configuration Error Calibration not Learned

DTC B1001 45
- Option Configuration Error Variant Not Programmed




Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) , prior to using this diagnostic procedure.


Circuit/System Description

The internal fault detection is handled inside the control module. No external circuits are involved.


Conditions for Running the DTC

The only requirements are voltage and ground.


Conditions for Setting the DTC

DTC B1001 4B

The module has detected that the axle ID number is not programmed.

DTC B1001 45

The module has detected that the restraints ID number is not programmed.


Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.
* A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.



Circuit/System Verification


DTC B1001 45
1. Program the restraints ID into the BCM.
2. Retrieve DTCs from the BCM. DTC B1001 45 should change to a history DTC.

• If the DTC remains current, replace the BCM.




Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) , after completing the repair.


Refer to Control Module References (Programming and Relearning) , for BCM replacement, setup, and programming.