B1023

DTC B1023

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptor
DTC B1023 00
- Integral Switch Performance




Circuit/System Description

The radio monitors the button presses on the driver information display. The radio will ignore any stuck buttons and allow full functionality of the working buttons. The only circuit required is the communications line.


Conditions for Running DTC

* System voltage is between 9-16 volts.
* Ignition switch is in the ON position.



Conditions for Setting DTC

This DTC is generated by the radio if a button is active for a period greater than 60 seconds.


Action Taken When DTC Sets

* The radio ignores continuous inputs from the button.
* The radio will respond to all other valid button inputs.



Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.
* The history DTC will clear after 50 fault-free ignition cycles.



Diagnostic Aids

Inspect the driver information display buttons for signs of damage or foreign objects. Operate each of the driver information display buttons and verify that the buttons have a smooth operation.


Reference Information
Schematic Reference

Radio/Navigation System Schematics (Radio/Navigation System Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Radio/Audio System Description and Operation (Radio/Audio System Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information.


Circuit/System Verification

1. Verify DTC 1023 is not set.

• If the DTC is set, clear the DTC. If the DTC resets, replace the driver information display.

2. Using the scan tool, select the data display under radio. Press any button on the driver information display. Verify that the radio button parameter displays the button being pressed.

• If the parameter does not display the button pressed, replace the driver information display.




Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Control Module References (Programming and Relearning) for Driver Information Display and Radio replacement, setup, and programming