Ignition Switch: Service and Repair

Ignition and Start Switch Replacement

Removal Procedure

1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair) .
Caution: Refer to SIR Caution (SIR Caution) .
2. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) Disabling the SIR in SIR.
3. Remove the Steering Column Trim Covers. Refer to Steering Column Trim Cover Replacement (Steering Column Trim Cover Replacement) .




4. Disconnect the ignition switch electrical connector (1).
5. Remove the ignition switch to steering column assembly retaining screws (3).
6. Remove the ignition switch (4) from the steering column assembly (2).



Installation Procedure






Important: The ignition switch groove must be correctly aligned with the ignition lock cylinder tongue.


1. Install the ignition switch (4) to the steering column assembly (2).

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the ignition switch to steering column assembly retaining screws (3).

Tighten the screws to 3 N.m (27 lb in).

3. Connect the ignition switch electrical connector (1).
4. Install the Steering Column Trim Covers. Refer to Steering Column Trim Cover Replacement (Steering Column Trim Cover Replacement) .
5. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair) .
6. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) Disabling the SIR in SIR.