Parking System Components Installation

Parking System Components Installation

Tools Required

J 44767 Seal Installer





1. Inspect the park system components for the following:

* Worn park pawl actuator brackets (607 and 608)
* A damaged or bent park pawl actuator assembly (613)
* A damaged manual shaft detent lever (600)
* A damaged manual shaft shift switch assembly (602)
* A worn or stripped manual shaft (606)
* A worn or damaged park pawl shaft (610), park pawl spring (611), and park pawl (612)
* A worn or damaged spacer (615), - some models.





2. Install the park pawl actuator brackets (607 and 608) onto the case.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the bracket retaining bolts (609).

Tighten the bolts to 22 N.m (16 lb. ft).





4. Install the park pawl (612), the park pawl spring (611), and the park pawl shaft (610) into the case.
5. Install the park pawl actuator (613) into the case.




6. Install the shift switch assembly (602) and spacer (615) - some models onto the detent lever (600).
7. Install the park pawl actuator (613) into the detent lever (600).
8. Install the shift shaft (606) into the case.




9. Align the groove for the NEW manual shaft pin (601) with the pin hole in the detent lever/shift switch assembly.
10. Install the manual shaft pin (601) into the shift shaft (606).




11. Install a NEW manual shaft seal (605) onto J 44767 .
12. Use a J 44767 to install the NEW manual shaft seal (605) into the case (604).