Scan Tool Data Definitions

Scan Tool Data Definitions
ANTENNA COIL
- The scan tool displays NORMAL/FAIL. The scan tool will display NORMAL if the antenna coil is OK or FAIL if the antenna coil is malfunctioning.

B+
- The scan tool displays BREAK/NORMAL. The scan tool displays BREAK if the power source is open or NORMAL if the power source is OK.

BCC
- The scan tool NG/OK. The scam tool displays NG if incorrect data is being sent or OK if correct data is being sent.

ENCRYPT CODE
- The scan tool displays NG/OK. The scan tool displays NG for data error or OK for data OK.

FRAME
- The scan tool displays NG or OK. The scan tool displays NG for data error or OK for data OK.

IG SW
- The scan tool displays ON/OFF. The scan tool displays ON if the ignition switch is in the ON position or OFF if the ignition switch is in the ACC position.

IMMOBILIZER
- The scan tool displays SET/UNSET. The scan tool displays SET if the ignition key is in the ON position or UN SET if there is no key in the key ignition cylinder.

KEY SW
- The scan tool displays ON or OFF. The scan tool displays ON if no key is in the ignition key cylinder or OFF if the key is in the ignition key cylinder.

MASTER KEY
- The scan tool displays MATCH/NOMATCH. The scan tool displays MATCH if the correct master key code is sent or NOMATCH if an unmatched code is sent.

PERMIT (START)
- The scan tool displays NG/OK. The scan tool displays OK to indicate that starting is permitted and NG if starting is not permitted.

REG CODE SPACE
- The scan tool displays FULL/NOT FULL. The scan tool displays FULL if any more key codes cannot be registered or NOT FULL if it is possible to register more key codes.

REGIST MAS CODE
- The scan tool displays the number of registered master keys. The minimum number is 0 and the maximum number is 15.

REGIST SUB CODE
- The scan tool displays the number of registered sub keys. The minimum number is 0 and the maximum number is 15.

RESPONSE
- The scan tool displays NG/OK. The scan tool displays NG for data error or OK for data OK.

SERIAL NUMBER
- The scan tool displays NG/OK. The scan tool displays NG for data error or OK for data OK.

STATUS
- The scan tool displays NG/OK. The scan tool displays NG for data error or OK for data OK.

SUB KEY
- The scan tool displays MATCH/NOMATCH. The scan tool displays MATCH if correct sub key code is sent or NOMATCH if an unmatched code is sent.