Tire Pressure Module: Service and Repair

Low Tire Pressure Indicator Module Replacement

Removal Procedure

1. Read the registered transmitter identification (ID) numbers. Write down the numbers in order to aid the re-registration of the ID numbers in the new module. Refer to Tire Pressure Sensor Learn (Programming and Relearning).
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair).
3. Remove the upper instrument panel assembly. Refer to Instrument Panel Upper Trim Pad Replacement (Service and Repair).




4. Remove the screw from the tire pressure indicator module (1).




5. Disconnect the connector (2).
6. Remove the tire pressure indicator module (1).



Installation Procedure





1. Connect the connector to the tire pressure indicator module (4).
2. Engage the tab (2) into the hole (1) and install the module.
3. Install the screw (3).
4. Install the upper instrument panel assembly. Refer to Instrument Panel Upper Trim Pad Replacement (Service and Repair).
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair).
6. Measure the tire pressure of each of the tires. Adjust the tire pressure to the specification on the tire placard, if necessary.
7. Register the transmitter ID numbers for all of the tires. Refer to Tire Pressure Sensor Learn (Programming and Relearning).
8. Initialize the system. Refer to Tire Pressure Monitor System Configuration (Programming and Relearning).