Tire Pressure Monitor System Configuration

Tire Pressure Monitor System Configuration

It is necessary to initialize the system when any of the following conditions occur:

* Prior to delivery of a new vehicle.
* After replacement of the tire pressure control module.
* After replacement of any of the tire pressure sensors.


1. If necessary, perform Tire Pressure Sensor Learn (Programming and Relearning).
2. Adjust all tire pressures to the proper specification.
3. With the ignition On, push and hold the tire pressure warning reset switch until the warning light blinks 3 times. Turn the ignition Off, then turn the ignition On again.
4. Using a scan tool, verify the tire pressures are properly displayed. If tire pressures are not displayed, initialization was not completed.