DME 7.2

P0450
99 Tank Pressure Sensor - Signal Implausible

P0452
99 Tank Pressure Sensor - Below Limit

P0453
99 Tank Pressure Sensor - Above Limit

Function
The pressure sensor transmits the signal indicating tank pressure during the fuel tank leak test.

Diagnosis conditions
- Ignition on

Wiring Diagram:

Diagnosis Procedure - DTC P0450:

Diagnosis Procedure - DTC P0452:

Diagnosis Procedure - DTC P0453:

1 Check wiring from pressure sensor to DME control module for short to ground.

1. Connect special tool 9637 to wiring harness (DME control module connector).
2. Remove connector of pressure sensor.
3. Connect ohmmeter to special tool 9637, pin IV/21, and ground.
Display: infinity ohms

If 0 - 5 ohms is displayed, check wiring for chafing and pinching damage.

2 Check wiring from pressure sensor to DME control module for short to B+.

1. Connect special tool 9637 to wiring harness (DME control module connector).
2. Remove connector of pressure sensor.
3. Connect voltmeter to special tool 9637, pin IV/21, and ground.
Display: 0 V

If battery voltage is displayed, check wiring harness for chafing and pinching damage.