Intake Camshaft/Hall Sensor - Delivered without Rotor
Boxster11/98 1505
Binder - 1, Engine, Part 2
Camshaft/Hall Sensor Rotor Installing
Date: 12-17-98
Vehicle Type:
Boxster
Model Year:
As of 1997 (V)
Concern:
Change of spare parts - intake camshaft.
Information:
Effective immediately, intake camshafts supplied as spare parts are delivered without the rotor (sensor tab) for the hall sender. A new rotor (996.105.129.52) must be fitted before a new intake camshaft is installed.
Parts Information:
996.105.221.04 Intake camshaft for cylinder bank 1 - 3
996.105.216.04 Intake camshaft for cylinder bank 4 - 6
996.105.129.52 Rotor (sensor tab) for cylinder banks 1 - 3 and 4 - 6
Work Procedure:
Fitting of rotor on the intake camshaft for cylinder banks 1 - 3 or 4 - 6.
- Clean the mounting area of the intake camshaft and rotor thoroughly (must be free from grease - e.g. with "Loctite Cleaner"). Coat the seating surface of the rotor with "Loctite 270".
- Affix the new rotor in the correct position by hand.
- On a workshop press, use the pressure piece - special tool 9628 - to press the rotor onto the seat of the inlet camshaft. Use pressure plate VW 402 as the camshaft support surface on the workshop press.
Literature:
Boxster Technical Manual, Group 2, page 28-2, section 28 44 19 - Removing and installing rotor for hall sender.
Warranty Info.:
Labor operation Time Units Description
28 44 23 50 20 TU Installing 1 rotor for hall sender
28 44 24 50 30 TU Installing 2 rotors for hall sender