DME 7.2

P1324
325 Position of Camshaft in Relation to Crankshaft, Bank 2 - Below Limit

P1324
325 Position of Camshaft in Relation to Crankshaft, Bank 2 - Above Limit

P1340
322 Position of Camshaft in Relation to Crankshaft, Bank 1 - Below Limit

P1340
322 Position of Camshaft in Relation to Crankshaft, Bank 1 - Above Limit

Function
When the engine is started and the reference mark has been recognized, the control module adapts the camshaft signal with respect to the reference mark, i.e. the software compensates for deviations from a fixed value by angle shifts. If these adaptation values reach their limits, the fault 'timing chain out of position' is recognized.

Diagnosis conditions
- Idle speed
- Reference mark recognized
- Engine speed between 600 rpm and 1200 rpm
- Engine temperature > 60 °C
- No fault in camshaft position sensors
- Reference mark OK
- No fault in camshaft adjustment
- No fault in engine temperature







NOTE: This fault can be stored only if the engine was disassembled and the allocation of the outlet camshaft to the inlet camshaft was incorrectly set. Adjust the camshafts.