PCM2/CDR23: 8025

8025 Navigation

Data CD read error

Diagnostic conditions
- Ignition on
- PCM2 on

NOTE:
- Fault code 8003 is recorded in the PCM2 MMI if the operating buttons are actuated for '≥ 1 minute'.
- Deactivate the 'automatic traffic announcement' before performing the diagnosis on the PCM2. If this is not done, the diagnosis will abort (applies only to software version [<] 03).

Possible cause of fault
- CD dirty
- CD scratched
- CD damp
- CD inserted incorrectly
- CD drive faulty
- Navigation module faulty

NOTE:
- The MOST optical waveguide is connected to the following control modules:
- PCM2
- CD changer
- Amplifier
- Telephone/telematics

Diagnosis/troubleshooting