Shift Interlock Solenoid: Service and Repair

Removing and installing shiftlock solenoid

Removal
1. Remove centre console.
2. Remove and install selector console.
3. Remove cover plate on selector lever support.





4. Pull off cable on manual switch, unclip holder for plug connection and remove cable from the cable guides.
1 Cover plate
2 Holder for plug connection





5. Pull solenoid holding clip only far enough away to permit the solenoid can be removed. Do not overstretch the holding clip.

Installation
1. Fit solenoid in correct position and properly route cable underneath the cable guides (see Figure).
2. Plug cable onto manual switch according to wiring diagram and fasten plug connection with holder on the selector support.