Removing and Installing Sealing Ring For Input Shaft

Removing and installing sealing ring for input shaft








Removal
1. Remove transmission.
2. Remove the release lever for clutch.
3. Remove guide tube for release bearing.





4. Screw special tool 9629 securely into the sealing ring.





5. Pull out sealing ring by screwing in the hexagon-head screw.

Note!
^ The coil spring must be pulled off the input shaft with a wire hook if the spring should jump down when removing the sealing ring.

Installation





1. Push assembly sleeve 9255 onto the toothing of the input shaft.
2. Fill the space between the dust and sealing lips on the sealing ring with grease (e.g. Liqui - Moly).





3. Drive in sealing ring with special tool 9628 as far as the mounting face.
4. Install guide tube for release bearing. Always renew fastening screws and tighten with 24 Nm (18 ft. lbs.)
5. Fit release lever with release bearing.
6. Clean teeth of the input shaft and grease with a thin coat of Olista Longtime 3 EP (available as spare part).