Body - Aerokit Spoiler Installation/Service: Overview
911 Turbo (996)4/03 6658
Binder - 6, Body Equipment
Aerokit "C4S" Installation Instructions
Date: 9-19-03
Vehicle Type:
911 Carrera 48 (996)
Model Year:
As of '02 (2)
Concern:
Aerokit MC4SVP installation instructions - Exclusive option No. "XAH".
Information:
The Aerokit consists of a spoiler lip and a rear lid with rigid spoiler. Based on the 911 Turbo design. The light panel characteristic for the 911 Carrera 4S has been successfully and smoothly integrated and the standard additional brake light is replaced by an new one integrated in the spoiler. These tested parts reduce the front-axle lift and rear-axle lift.
Note:
The spoiler lip and the rear lid with spoiler must always be mounted together on the vehicle. Installation of single parts is not permitted and not approved!
The Aerokit "C4S" is also available as a factory installed option for new vehicles - 911 Carrera 4S (996) - under Exclusive option No. "XAH".
Parts Information:
Warnings:
Caution!
Risk of damage to the accessories or to the overall vehicle - due to the smaller overhang angle of the front spoiler in relation to that of the standard part.
> The bottom of the spoiler can scrape on the ground when the vehicle is loaded or unloaded or driven in parking garages with very steep ramps.
> Avoid steep access and exit ramps wherever possible.
> Adapt your driving style to the local situation.
Caution!
Risk of damage to the accessories or to the overall vehicle - when cleaning the vehicle in automatic car washes.
> Accessories such as spoilers might not be adequately recognized by the light barrier under certain circumstances. In cases of doubt, consult the car wash operator or only manually clean the vehicle.
Caution!
Risk of damage to the accessories or to the overall vehicle in the case of misuse or improper use.
> Rapid opening of the rear lid can cause damage to the spoiler or rear wiper. Check and optimize the gap dimensions of the rear lid. Open rear lid carefully.
> Never use the spoiler to push the vehicle.
Caution!
Damage or warping can occur on components - in the event of improper painting and drying processes.
> Observe the specifications and instructions for the painting of plastics as contained in the Paint Manual.
> During the painting and drying process, place the parts free of tension on the painting fixtures provided for this purpose.
Please inform the customer about these "warnings" and provide the customer with a copy.
Material:
Tools:
Phillips screwdriver
Side cutters
Screwdriver
Torx screwdriver T 25, T 30
Ratchet
Extension for ratchet
Socket a/f 10
Tape measure
Open-end/ring wrench, a/f 10
Knife
Key file
Porsche System Tester (PST2)
Working Time:
Literature:
911 Carrera (996) Technical Manual,
Groups 5/6/9
> Repairs
5 - Gap dimensions, body rear
50 90 19 - Removing and installing rear lid
55 90 37 - Disassembling and assembling rear lid
63 15 37 - Disassembling and assembling front spoiler
94 33 19 - Removing and installing bulb for tail light
Disclaimer