Pedal Encoder

Removing and Installing Pedal Encoder

Removal

1. Pull off the centre air duct (A) in the driver's footwell.







2. Undo two hexagon nuts (a/f 10 mm) on the pedal encoder.







3. Disengage electrical plug connection on the bracket. To do this, turn the plug connection counter-clockwise in the bracket and take it off. Disconnect plug connection.
4. Pull pedal encoder out of the stud, disengage the cable from the cable disc and remove the pedal encoder in downward direction.

Installation

1. Engage cable in the cable disc, insert the pedal encoder in the stud and fasten the pedal encoder with two hexagon nuts.
Tightening torque 8 - 9 Nm (6.0 - 6.5 ftlb).
2. Position electrical plug connection in the bracket and turn it clockwise until the plug connection engages.