Procedures

Removing and installing torque converter




Tools

Notes on removal and installation
Removal
1. Remove multi-function switch.
2. With transmission in horizontal position, carefully remove the converter.

Installation





Note: Check converter hub for traces of scoring. In the event of damage or faults, the complete converter must be replaced.

1. Carefully push converter onto transmission shaft as far as the first stop. Then press converter by hand into the converter bell housing and turn it until the recess in the converter hub engages in the driver of the impeller and the converter perceptibly slides inward.





2. Hold the converter in installation position with special tool 9595/1 (long).

Note: If the installed position of the converter is incorrect, the ATF pump can be destroyed when the transmission is flange-mounted to the engine.