Test Point 6

Fault, DTC 63 Test Point 6

Shiftlock P/N lock Open circuit/short to ground, short to B+

Possible causes, elimination, notes

Fault effect:
Fault is only entered in the fault memory.

NOTE: When the ignition is on, a transmission range can be selected from the selector lever position P or N only if the foot brake is pressed in addition.

1. Check lifting solenoid with wiring. To do this, connect an ohmmeter to control module connector pins 2 and 53 and measure the resistance.

Nominal value: 60... 90Ohms.

2. Check wire from control module connector pin 2 to the lifting solenoid connector pin 5 for continuity, short to ground and short to B+.

NOTE: The lifting solenoid connector is accessible only if the centre console is removed.