Vehicle Hand-Over

Vehicle Hand-Over

The PCM2 is converted to delivery mode (low-current mode) in production. As known from other systems (alarm system, instrument cluster, roll-over bar), the PCM2 must be activated with the Porsche System Tester II 9588.
1. Connect and start the Porsche System Tester II 9588 and switch on the ignition.
2. Select Special functions in the Vehicle type menu and confirm with the >> key.
3. Select Vehicle hand-over in the Control modules menu and confirm with the >> key.
4. Follow the instructions of the Porsche System Tester II 9588.

Air conditioning
The following versions can be coded:
- Without air conditioning.
- With air conditioning.

Coding country-specific tuner settings
1. Connect and start the Porsche System Tester II 9588 and switch on the ignition.
2. Select 911 Carrera (996) in the Vehicle type menu and confirm with the >> key.
3. Select PCM in the Control modules menu and confirm with the >> key.
4. Select PCM2 GW in the PCM2 function selection and confirm with the >> key.
5. Select Coding in the PCM2 GW function selection and confirm with the >> key.
6. Select Tuner parameters in the PCM2 GW coding function selection and confirm with the >> key.
7. Take the country-specific code as it appears in the table, enter it in the form and code with the F8 key

Country-specific tuner settings
The following country-specific tuner settings can be coded:
- Asia.
- Australia.
- Europe.
- Japan.
- North America.
- South Africa.
- South America.

MOST switch
The MOST switch is part of the PCM2. If external MOST control modules are present, they will only work if the MOST switch is open.

The following settings can be coded:
- MOST switch open.
- MOST switch closed.

NOTE:
- When the PCM2 is replaced, the coding must be performed in accordance with the vehicle equipment.
- When the Switch closed parameter is set, the switch remains closed even in existing MOST control modules. Communication is then not possible.

Coding PCM2
1. Connect and start the Porsche System Tester II 9588 and switch on the ignition.
2. Select 911 (996) in the Vehicle type menu and confirm with the >> key.
3. Select PCM in the Control modules menu and confirm with the >> key.
4. Select PCM2 GW in the 911 PCM2 function selection and confirm with the >> key.
5. Select Coding in the PCM2 GW function selection and confirm with the >> key.
6. Select PCM2 code in the PCM2 GW coding function selection and confirm with the >> key.
7. Take the PCM2 code from IPAS, enter it in the form and code with the F8 key.

Production mode
If the MOST control module is set to Production mode on, it is in low-current mode. This status is indicated by the message PROTECTED on the display. The control module cannot function. If production mode is coded out, the control module is operational again following a restart (vehicle must be locked and secured).

The following options can be coded:
- Production mode off.
- Production mode on.

Control module replacement - PCM2
The PCM2 is supplied in production mode on in new vehicles and as a spare part. If production mode is coded out, the control module is operational again following a restart (vehicle must be locked and secured).

Each time the vehicle is started, the model range code that is stored is compared with the code in the instrument cluster. If no match is found, the device switches off after 30 seconds and the PROTECTED message appears in the display. The device is not operational.

If a match is found, the device is operational. No further checks are made while the device is connected to the vehicle electrical system.