Removing and Installing Bulb For Auxiliary Headlight (High Beam Headlight)

Removing And Installing Bulb For Auxiliary Headlight (High Beam Headlight) As From Model Year '02

Removing bulb for auxiliary headlight

INFORMATION: The bulb for auxiliary headlights (high beam headlight/headlight flasher) is located beneath the lamp for dipped beam/high beam headlight.

1. Switch off light. Remove main headlight







2. Unscrew fastening screws -A-, press both releases -B- and remove the rear cap -1-.







3. Turn the bulb holder -arrow-. Turn counter-clockwise on the left headlight and clockwise on the right headlight. Take the bulb holder out of the headlight housing.
4. Pull both releases of the plug -arrows- apart. Pull plug out of the bulb holder.

Installing bulb for auxiliary headlight
1. Engage electrical plug connection -arrow-.







2. Guide the bulb holder into the headlight housing and turn clockwise on the left headlight and counter-clockwise on the right headlight. Ensure correct seating.







3. Put the cap -1- into position and press down until both locking tabs -B- engage. Screw in both fastening screws -A-. Tightening torque: 4 Nm (3 ftlb.).
4. Install main headlight and perform a function test.