Overhaul

Disassembling And Assembling Rear Lid - Carrera 4S

Tools










Disassembling rear lid










Assembling rear lid










Removing and installing additional brake light

1. Removing additional brake light







1.1. Unclip cover -A- at the sides, unlock lock -B-. Remove brake light and disconnect plug connection -C-.

2. Installing additional brake light







2.1. Push on plug -C-. Insert brake light. Lock the lock -B-. Clip in the cover -A-.

Installing rubber covering - Cabriolet

Fitting rubber covering

1. Clean bonding surface with cleaning agent.
2. Pull off protective film -A- on rubber covering -18-.







3. Position rubber covering -18- on the dimension -X = 0.5 mm- and stick flush into the lid over the entire length.







Removing and installing reflector cover

Removing reflector cover







- Unscrew fastening screw -27- from the reflector cover -28-.

Install reflector cover

- Secure the reflector cover -28- with the fastening screws -27-.

- -> Test and adjustment values

Removing and installing wiring harness

Removing wiring harness







1 - Press the lug of the electrical plug connection, see inset -arrow- and separate.
2 - Remove additional brake light.
3 - Pull out grommet -A- with brake light lead. Disconnect plug connection -B- for fan on fan housing. Disconnect plug connection for engine compartment lighting -C-. Press the fastening clips -arrows- together from the inner side of the mount and and remove.

Installing wiring harness







Replacing the model logo







1. Find the middle of the lid.
2. Position logo -Carrera- with the dimensions -A = 185 mm- and -B = 31 mm- on the rear lid and affix.
3. Position logo -S- with the dimensions -C = 185 mm- and -B = 29 mm- on the rear lid and affix.
4. Insert logo -4- in the external cut opening -arrow- of the logo -S-.

Test and adjustment values

INFORMATION: Illustration of the gap dimensions. Refer to Diagram - body gap dimensions







Tightening torques







Materials and tools