Roll Bar Control Module: Service and Repair

Removing And Installing Control Module For Roll-over Protection System

Tools







Removing control module

1. Remove ignition key
2. Disconnect the battery and cover terminal or battery.
3. Only loosen the centre console and move it forwards a little. Refer to Removing and installing center console
4. Remove the two rear belt buckles and take out the seat wells.
5. Undo the trim of the seat wells from the carpeting and lift up in the middle.
6. Using a support tool, support the trim and unscrew and remove the plastic screw from the control module cover.







7. Disconnect the electrical plug connection. Undo the shear-off nuts with socket wrench insert and remove the roll-over protection control module.







Installing control module

1. Install the roll-over protection control module in the centring holes with the fixing pins, and secure with shear-off nuts.
2. Use a 1/4 inch Allen key to tighten the shear-off nuts.
3. Engage electrical plug connection and route wire carefully. Install control module cover, seat wells, belt buckles and centre console.
4. Following the installation of a new control module for the roll-over protection system, the transport lock must be deactivated with the Porsche System Tester 2.

Tools and materials