Rear Side Section Flap

Overview:

Exploded View:

No. 1 - 5:

No. 6 - 9:

Adjusting the gap dimensions of the rear side section trim

Measurement Locations:

Adjusting gap dimensions
(Convertible top open and set down.) Insert a plastic spatula under the trim and press it out. The adjustment, Figure C, is made by means of the Torx screws in the flap.

Dimension A = 4.0 + 2.0 mm gap width between the rear side section trim and side section trim.

Dimension B = 3.0 + 2.0 mm gap width between the roll-over protection system cover and rear side section trim.

Dimension C = ± 1 mm offset between the roll-over protection system cover and rear side section trim.