Left / Right Traffic Conversion For Litronic Headlights

Left / Right Traffic Conversion For Litronic Headlights

WARNING:
Warning signs (yellow triangle with black high-voltage arrow) indicate high voltage (risk of fatal injury).
- The light must always be switched off when removing and installing these components (control module, ignition unit, gas discharge lamp, servo motor). Once removed, a headlight is not under high voltage.
- The gas discharge lamp (D2S lamp) may only be operated when installed in the reflector and with the headlight installed.

INFORMATION: Masking film for left/right-hand traffic must not be affixed to Litronic headlights. These headlights incorporate a changeover lever for driving in countries with left/right-hand traffic. This lever is located on the left and right on the housing in front of the gas discharge lamp.

Changing over Litronic headlights
1. Switch off the light. Release the headlight housing and pull out forwards slightly.
2. Disconnect the electrical plug connection of the automatic headlight beam adjustment and remove the headlight housing.
3. Release and open the cover with control module.







4. Push the changeover lever A to position T (tourist setting).

Installation
1. Lock the cover with control module and insert the headlight housing in the wing.
2. Engage the electrical plug connection of the automatic headlight beam adjustment and lock the headlight housing in the wing.
3. Repeat the changeover procedure for the other headlight.