Removing and Installing Cover For Final Drive

392019 Removing and installing cover for final drive

Tool










Removal

1. Drain transmission oil.
2. Remove drive shaft at the transmission and protect the shaft against damage (use scrap pieces of hose with a diameter of 30 mm).
3. Remove halfshaft flange.
4. Unclip hydraulic line for clutch slave cylinder.
5. Unscrew hexagon-head bolts for cover and press off cover on alternate sides.

Installation

Tightening torques:
Cover for final drive to transmission (M8) = 25 Nm (18 ftlb.)
Drive shaft to transmission flange (M10) = 81 (60 ftlb.)
Oil filler and oil drain plugs (M22) = 30 Nm (22 ftlb.)

1. Fit sealing ring untwisted.
2. Coat sealing ring with transmission oil and fit cover. Use special tool 9321 to aid assembly.
A - Centering pins 9321