Procedures

Fitting Six-Point Seat Belt - GT3
The six-point seat belt is not fitted for the Club Sport equipment when the vehicle is delivered.

NOTE:
- Six-point seat belts are intended only for competitive use.
- Three-point belts must be fastened when driving on public roads.
- The legally permissible treatment must be obtained from the relevant national importer.

1. Loop technique for fastening the seat belt to the bucket seat cross member







- Loop the belt strap in the direction of the arrow -inset- around the front transverse strut on the bucket seat into the adjustable slider. The projection -dimension = X- of the belt strap must be at least 100 mm.

2. Pulling six-point seat belt through the openings in the bucket seat







- Pull six-point seat belt through the upper openings in the backrest from behind -arrow A- and through the openings in the seat frame from the side -arrow B-.

3. Fitting belt fitting







- Position foam part -4- and belt fitting -5- at the left and right on the seat frame. With the shim -3- and the fastening screw -2-, screw the belt fitting -5- tight. Position the cover -1- on the fastening screw -2-.
- Use the foam part -4- for the Club Sport version.
- For the Cup racing version, mount the bushing -6- instead of the foam part.

Tightening torque: 50 Nm (37 ftlb.)

4. Loop technique for fastening the seat belt to the bucket seat cross member







1. Loop the belt strap in the direction of the arrow -inset- around the transverse strut on the roll cage into the adjustable slider. The projection -dimension = X- of the belt strap must be at least 100 mm.
2. Roll up the projecting belt strap and bind it with a tie wrap -1-.